Tandy 3000 keyboard foot

I bought a Tandy 3000 keyboard and one of the foots was missing, so I made one in FreeCAD.
It works fine, it even locks in place like the original foot, as it is shown in the pictures.

Improvements:
It is not as tight as the original so it rattles a little, it might need to be about 0.5mm wider.
The two small pivot shafts can have some printing imperfections because of the overhangs. Maybe this could be avoided by making a multipart print.

Print:
Although rafts should not mater, I get better horizontal cylinders if I have them

Can send the FCStd file if requested.