Trion BCAR Remix (improved stock screw fitting) 8 degrees and 15 degrees

The original that Anaphalaxas made is amazing and greatly improved accuracy. One of my favorites and use it for all my trions. But it wears down the nobs on the blaster
because the tabs on the original are about a millimeter too far to the right and too thick. so on this remix I fine-tuned the screw fitting and the tip end because I like the machined look.

If this worked for you please leave a comment. I would love to hear about it.

Includes:

• Step file for the improved screw mount only for designing.
• 8 degree
• 15 degree

*** Version 3 is slightly tighter fit on the Trion screw with less wiggle. (added April 15)

Printing Advice:
walls: 4
support: Default and build plate only
(this will force it to only print supports inside where it's needed. The rest will print fine without supports.)

Hardware:
Takes 9 F683ZZ (3mm x 7mm x 3mm) flanged ball bearings.
Takes 9 3mm x 14mm steel pins. These can be had on Amazon, AliExpress, and numerous other outlets.