Lian Li Computer Motherboard Standoff

For old Lian Li cases with square holes & clips for mounting the motherboard standoffs. Melt an M3 ~7 mm height threaded insert in the thin end of the 3D print. Drive the standoff flush or slightly overdriven so the motherboard has a smooth and flat surface to rest on. Attach the standoff to the case with M3 screws and enough washers to leave room inside the threaded insert for the screws that secure the motherboard.

Printed with standard filament and ~3 mm thick perimeters and top/bottom and 100% infill.

Area for improvement: the standoffs rotate slightly when being screwed into the case, and don't seem as consistently centered as I'm used to. Not sure if this is due to the square alignment lip being smaller than it needs to be, or from overstressing cheap filament. Motherboards will mount fine though as they use oversized holes to permit this.