Summary

This is a wheel used by gardeners and farmers to produce holes in the ground where items can be planted. A friend needed a new wheel, so I produced this design. Unfortunately it was too large for my Prusa MK4 and I had to break it into three pieces, then epoxy them together. I'm including the full part for those lucky enough to have a larger printer.
Revision 1, I've added the dibble part that will actually poke holes into the ground.

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>i3 MK4</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.3</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>40%</p></div></p>                                                                                <p class="detail-setting filament_material"><strong>Filament Material: </strong>                     <div><p>PETG</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I used PETg due to the UV protection that was needed.  My initial print was with PLA, knowing it was only a short term fix.  I painted the PLA print to protect it.  The PETg should be good to go.<br>For the Dibble itself, you will need to program in a pause at the layer that the 1/4-20 nut can be inserted into the print.  The cavity for the nut tapers above it (as the dibble is pointed up) at a 45 degree angle so all printers should be able to produce this.</p></div>

Post-Printing

Glueing

            <div><p>If you need to print in three sections, use JB Weld or some other epoxy designed for plastic to glue together.</p></div>                <p class="detail-title"><strong>Assembly</strong></p>            <div><p>Since there is a 1/4-20 nut inside the dibble itself, there is a 1/4-20 x 1" screw needed to attach it to the wheel.  I suggest that a 1/4" drill be used to clear out the holes around the wheel first before assembly.</p></div>

Dibbler