Raspberry Pi 2 B Shelf Slide Bracket for Makerfarm i3v 10"

After trying a couple of different raspberry Pi cases, I started looking at my printer to see where I might be able to attach it directly without it just laying on the table. It dawned on me that I could design a shelf bracket to slide over the wood on the left side & have the P/S support it without having to use any additional hardware. I have printed about 3 hours with it sitting there & it has stayed in place quite well. I have not decided where to put the PiCam yet, but will add it to this design later.

I also added 4 wire tie holes on the end if you wish tie your cables off.

I used http://www.thingiverse.com/thing:402498 as a guide for the size of the board. I see there is version for the Pi 2 that I did not see before. http://www.thingiverse.com/thing:697403