Falcon 2 Pro 40 watt Magnetic Drawer Defeater

This is a small print with two inserted magnets that will defeat the safety device on the Falcon 2 Pro 40 watt drawer. This is needed if you want to raise the engraver on legs to engrave on something taller than will fit in the machine. I raised the laser with Leg Risers I printed Thing # 7055235.
After printing the STL, superglue two 8mm x 3mm magnets in the holes. I checked the polarity of the magnets by sticking them on the magnets in the drawer. I don't know if this matters but I made it the same as the ones in the drawer. Just line up the end of the print with the left edge of the drawer opening, I used masking tape to hold it in place. This worked perfectly for me. As you may know, the laser unit is limited in how far down it will go. On the back of the laser module, there is a slot milled into the part that slips into the holder on the carriage. That part is aluminum and could easily me milled further up the module case to allow the laser to go lower. I intend to do this to mine when I get a minute.