FlySky FS-i6 Winch/Rudder Gimbal Plates

I have seen DF95 Sailors glue their Transmitter Gimbals to keep them at up/down for the Winch Servo and Left/Right for Rudder Servo. This causes issues if you need to do some factory setting adjustments and I created these Gimbals after seeing them made for other transmitters to control transmissions on vehicles. These are setup for the FlySky FS-i6 Transmitter and have WINCH & RUDDER on them, since each is specific to a particular gimbal. The remote has a sloped face to at each stick, so they are sloped to match. They are setup to print face down and then double sided scotch tape can be used to hold them in place in addition to the sticks holding them in place. The tape just keeps them from turning and the excess tape can be cut off w/ an Xacto knife once in place.

There is another version of the Gimbal Plates w/ WINCH & RUDDER removed (View in 3D to see the difference), but they are meant to go on the same sticks due to the slope of the surface to match the FlySky FS-i6 Transmitter. If switching sticks, you will need to rotate the plates 180 degrees to have the surface align w/ the remote ring.