Shelf stand support

I want to add a shelf to a small desk and I made this support so that I can use a piece of some home depot 1.5" x 2' ABS SCH 40 CUT PIPE piece. It's what I bought since it wasn't too big in diameter but strong enough for a small shelf to hold a lamp, soldering station and small charger. This was plenty for two supports. So you will need to at least print four of these or however many you need depending on your shelf.

Note:
I just put the shelf together and it's lose and wobbly, so don't use this just yet. I'm making a few changes and will update once that is done to make sure it's more stable.

Okay, I have fixed this and now the pvc fits the way it's supposed to. There is now more support on the height. I also increased the base by 3 mm to give it a bit more surface area. So you should be able to make a nice shelf now. Sorry about that, I had not built the shelf but now I have and it works. The file old file has now been replaced with the updated one.