Winwing Orion 2 Throttle Overlays (small format friendly)

Since I don't have a large format 3D printer to print a full overlay for the Orion 2 throttle, I created these. I created a set of blank overlays you can modify as you see fit. The fit is fairly exact and scaled according to the PLA I used. I left a gap for the Jettison button. I recommend printing a few layers (face down) as a template and see if you need to scale up or down.

Depending on what others think, I might make one for the middle section. That said, for my own needs I didn't see the point.

I use my throttle solely for Star Citizen, so I also created a version with my preferred key mappings. These are designed specifically for my single filament printer and involves swapping filaments. Designed with 0.12mm quality in mind, these make use of the LED lighting underneath rather that obscure it. I printed them as follows

Printed face down on a PEI plate
0.12mm Quality, all the cooling possible
In slicer, set a pause at end of layer 2 (or layer just below text) for swapping filament
In slicer, set a pause at end of layer 6 (top layer of text) for swapping filament
Start with Clear PLA, swap in Black PLA, then swap back in Clear PLA

Feel free to remix your own, and it would be great to see them.

Have fun flying, Nom