GT2 Y Motor Mount for Printrbot Simple

I was trying to use iamjonlawrence's GT2 kit on my 2014 printrbot simple, but the GT2 pulley I bought was too large for it. if you've run into this problem this may be the motor mount for you. I designed the whole thing in google sketchup. it has a larger width between bearings as well as a higher offset from the Z carriage. there is a flat side on the right so it doesn't collide with the Y carriage when zeroing, however be careful as you may have to adjust your endstop or file away at the wood a little bit. use 608ZZ skateboard bearings