Bottle Storage Hanger Rack for Fume Hoods

This design will allow you to hang up three typical chemical solvent bottles in your hood on existing cross-bars.

You will need to print:

(1) Base
(2) Leg

Pick the Leg model that matches your stand-off needs to level the Base.

You will not need supports for any of these models.

You will also need some hardware for assembly:

(4) #4-40 Screws (¼" to 3/8" in length)
(4) #4-40 Nuts (¼" drive)

These work well for screws:
https://www.mcmaster.com/92949A108/

And these work for Nuts:
https://www.mcmaster.com/91841A005/

Your nuts will be captured, so you will only need the driver for the screw.