LG Flatron IPS237L VESA adapter mount

This is an adapter plate for an LG Flatron IPS237L. It puts a VESA 75 x 75mm on your monitor, though you can change it to 100mm VESA easily to do if you know some Fusion360 or Blender.

I chose to put the mount below the plugs rather than have a large extension to above the plugs, so that designing is easier, it's a bit stronger and also faster to print. You can use the slits (50 degrees, 4mm wide) to slide in a small parts tray or something similar, depending on your liking (I haven't made any of them). This would also cover up the front screws.

Installation procedure:

1. Print
2. Insert 4 M4 nuts
3. Use the two screws of the original mount (M4x10) to mount the adapter to your monitor (screw in tight!)
4. Attach the adapter to your VESA mount