Simple Two Piece Phone Stand

For the inlays, make sure to print the inlay first then using Z-hop set at 0.4 mm to print the main piece.
Make sure when printing that both inlay and main piece are centered on the printing plate.

This video has a good explanation on printing inlays with Z-hop: https://www.youtube.com/watch?v=CZowfbkz0pw

I tried to create designs without inlays as well if you don't want to mess with it.

I've included 2 different "leg"/bracket designs as well.

The characters were from various designers I had found on Thingiverse as noted below. If there is interest, I will try and put up some more as I find other characters/logo, etc.

Remixes from:
Gamer Dog - u/Longquang
Owl - u/wslab
MHA - u/kilkzad
MSI Dragon - ForceVenom