Ubiquiti Pro Max 16 Rack Mount Kit

This model allows you to rack mount Ubiquiti Pro Max 16. The model is identical both sides (just print x2 copies) and centers the switch directly in the middle of the rack.

It has no support to hold the power brick (I have a shelf not too far under the switch which the power brick rests on).

I used M4x10mm with some washers to fasten the models to the switch.

Added triangular cross hatch support for extra strength.

Known issue: when fastening the model to the rack, be gentle to ensure only firm and secure, overtightening the large screws crushes the plastic and snaps the small wall near the hole. I did think about increasing the width of the wall surrounding the hole, but it then would result in a taller design and intruding into other rack units.

Material: PLA
Infill: 50% for extra strength
Support: Yes (on model too, only 1 tiny support if printed in upright orientation - w/ Bambu Lab as slicer)
Printer on: Bambu Lab P1S
Print time: ~2 hours each side