300 BlackOut Dillon and Hornady case feeder plate

Remix of the Small Rifle case feeder plate with adjusted openings optimized for 300BO! Thanks to @Harambebot for the initial design.

I print these in PLA Tough, .4 nozzle and 2 walls, with .8 upper and lower shells and 10% gyroid infill. For the clutch parts, I print them 2 walls 100% infill and have never had any failures. Works perfectly!

With a Dillon, adjust the case wedge with the screw closest to the operator all the way DOWN and the rearmost screw all the way UP, and put a small piece of masking tape over the sharp corner of the wedge on the inside. Adjust the metal spacer to position #6.