Microwave Bulb Base Remover

Always unplug your microwave before trying to remove the bulb

If you're like me and have a burned out light bulb (the one under that's a night light, not the inside of the microwave) in your over stove microwave that is the original bulb, you might break the bulb off the base and have the base stuck in the receptacle. I modeled this, wrapped a rubber band around the end a few times and used it to remove the base from the hard to reach, no space to work, facing away from me receptacle. Printed in 15 minutes on my P1S using .2 layer height, 2 walls, 5% infill with PLA+. Cost a whopping 2 cents. Hope it helps, may need to scale appropriately for different applications. Don't forget to unplug your microwave before any of this.