Aldi Activ Energy battery holder - with pegboard mounts

I remixed this already perfect mount for Aldi Activ Energy batteries by removing the countersunk screw holes and adding 2 lugs on the back so that they can be clipped into a generic peg board.

So you can check if you have the same boards, the pegboard specs are:
Center to center (both vertical and horizontal): 50mm
Top hole diameter: 10mm
Lower slot width: 5mm

The lugs give a really positive fitment in the pegboard so you can unclip the battery and lift it out without the bracket lifting out of the pegboard.

Printing instructions:
I used Sunlu PLA+ 2.0
Keep them standing vertically
3 perimeters
25% infill of your choice
Paint support under the mushroom lug heads at 55 degrees then enable manual tree supports
Go!
~35 minutes each on my Bambu Labs X1Carbon

Big thanks to xaver25 for the perfect bracket.