Summary

I bought a cheap ratchet set that was on clearance at Menards, and it didn't have a case come with it. So, I figured I might as well design a wall mount for it.

The ratchet set is a 1/4 inch drive and bit set. The holes are 12mm in diameter for the sockets, and 8mm at it's widest for the bits. The mount is designed to be used with two pairs of Command Velcro strips.

Print Settings

Rafts:

No

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                                                <p class="detail-setting filament_material"><strong>Filament Material: </strong>                     <div><p>PLA</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Make sure you set the print with the command strip side flat on the bed. There's a picture to show.</p></div>

Ratchet Set Holder for the Wall