Activation Index (Halo 2) REMIX / FIXES

Added the details back to activation_index_combined, fixed the bowed bottom of activation_index_light. Remember to print 2 activation_indexbuttons(print_In_Clear_x2) and activation_index_lightFLATTEND(print_In_Clear_x2) in clear filament.

I HIGHLY RECOMMEND PRINTING WITH THE FOLLOWING SETTINGS. I WAS ABLE TO PRINT ALL PARTS SIMULTANEOUSLY ON A SINGLE 300x300MM PRINT BED.
(Slicer used: Creality Print | | Filament used: Creality Hyper Series)
Layer height: 0.2
Wall loops: 2
Infill pattern: Cubic
Infill density: 10%
Supports: Enabled
Support type: Tree (auto)

I also recommend placing activation_index_combined_DETAILS_ADDED in the orientation provided (top side down).
Parts list taken from comments of OP, from mman360
"
2025 Parts update

I used these LED strips for the light up the index.
https://www.amazon.com/dp/B0CKYFLZFQ?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
I used 9 segments on each side and taped it back to back. I soldered the 2nd side at the base + to + and - to -.

I used this dimmer cause the LEDs are bright.
https://www.amazon.com/dp/B092HX9435?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

I used this power supply
https://www.amazon.com/dp/B077PW5JC3?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1https://www.amazon.com/dp/B077PW5JC3?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
"
You will have to drill a hole or add one in the slicer for both the wire through the base "11mm", and also drill out the holes "at the top of the index for light to pass through".
Additionally mman360 opted to use an LED strip and skip the rod all together. If you opt for a rod and single LED approach, the rod will have to be 12mm in diameter.