Summary

This was made with an LED strip, Creality Ender 3 v3 se, grey filament, and clear filament. Parts are put together with plastic welding, however glue/double sided tape could work too. You will also need tape. Use at your own risk. I did not do the art inside; a friend did that.

Post-Printing

Parts to print

            <div><p>Bench, diffusive layer, and frame holder should all be printed clear, everything else can be whatever color you like. Empty frame is just for remixes. I used 8 frame holders and 2 benches, but those aren't exact numbers.</p></div>                <p class="detail-title"><strong>Assembly</strong></p>            <div><p>Assembly is pretty simple, just note that the bevels on the bottom are smaller than the top. To assemble, loop the led strip around the inside of the box, I recommend spacing each ring evenly, attach the controller on the back near the hole, use the Frame holders (I used 8, but fewer would probably work) to place the frames in order and glue/weld, tape the diffusive layer to be a full loop and put it over the prongs on the front part. I also connected this with a solder iron. Finally attatch the "benches" (I used 2) to the botton of the diffusive layer to support any models placed inside.</p></div>

LED Lightbox/display