Speedlight Double Mount
This double holder for speedlights allows you to use two speedlights on one umbrella holder at the same time, thereby doubling the light intensity.
ColdShoe Double Flash Holder_1 and ColdShoe Double Flash Holder Spigot assembled together form a complete printed system, as shown in the picture. Depending on the print quality, you may need to sand down the opening for the spigot slightly and then insert the assembled spigot with superglue.
If you have separately available metal spigots and 1/4-inch screws, you can use them together with ColdShoe Double Flash Holder_2.
Print everything with 100% infill and in 0.16 mm layers for maximum strength. I printed it with PLA and it holds up perfectly. Nevertheless: use at your own risk! Have fun and good luck with it ;)
Diese Doppelhalter für Speedlights versetzt Dich in die Lage, zwei Speedlights an einem Schirmhalter gleichzeitig zu nutzen und die Lichtstärke damit zu verdoppeln.
ColdShoe Double Flash Holder_1 und ColdShoe Double Flash Holder Spigot zusammen montiert ergeben ein komplettes gedrucktes System, wie im Bild zu lesen. Je nach Druckqualität muss man nur die Öffnung für das Spigot etwas ausschleifen und dann das zusammengebaute Spigot mit Sekundenkleber einfügen.
Wenn Du über separat erhältliche Spigots aus Metall verfügts und über 1/4-Zoll-Schrauben, kannst Du diese mit ColdShoe Double Flash Holder_2 zusammen nutzen.
Drucke alles mit 100% Infill und in 0,16 mm Layer für maximale Stärke aus. Ich habe es mit PLA gedruckt und es hält optimal. Dennoch: Verwendung auf eigenes Risiko! Viel Spaß und Erfolg damit ;)