Smartphone holder - just another one - but helpful

There are so many mobile phone holders, but I needed one that could hold even "thick" mobile phones with a case. Here he is.
I haven’t found anything similar, though that doesn’t mean it couldn’t be a remix — there are just so many out there.

Tips for printing
Very simple – without support, without additional plate adhesion, can be printed quickly
Attention: pay attention to the correct orientation when slicing (as a wall)

• PLA or any other filament materials
• Nozzle 0.4mm always fits
• Nozzle Temperatur 220°C
• Build plate: Temperature: 60°C
• Color according to personal wishes
• Estimated time: around 20 min (with my 3D Printer, maybe you have to fast one)
• No post printing is necessary

Construction
Only the functionally important curves were included directly in the sketch. Laps were set in the 3D model as needed.

Dimensions (single): W 60mm x H 15mmm x 60mm
Large slot: 15mm (can be customized directly according to mobile phone)
Small slot: 10mm (can be customized directly according to mobile phone)