11 Tooth 3pc Gear Fidget

Design Concept:
Mainly was trying to build something from scratch, and I think it turned out pretty well! have printed this on my own printer and is a nice semi-silent fidget to have during the day! The bottom black layer you see in the photos is a bit thin, so be careful to not be too rough with the bottom.
Print Settings:
NO SUPPORTS
15-20% Infill works best
Printed on Creality K2 Plus
Used Creality CFS for multi-color
Assembly:

PRINT IT
TAKE A PHOTO OF IT
UPLOAD A MAKE OF IT
Note: [Directions 2 & 3 are optional, but highly encouraged!]
In the TOP LEFT SNAP, (The blue one in the photos) Snap the BIG GEAR into place.
In the BOTTOM RIGHT SNAP, (The red one in the photos) Snap the SMALL GEAR into place
Done! Have fun with your brand new 11 Tooth Gear Fidget!
Note: [On the version I printed, the rotation only worked smoothly when rotating the big gear, not the small one]

Check out my other designs~
https://www.crealitycloud.com/user/9008057687?tab=0
https://www.thingiverse.com/PrintForge_Official/designs
https://www.printables.com/@PrintForge_Official
https://makerworld.com/en/@Helloes/