Skadis Adhesive Wall Mount (for M4 Nut)

These are wall-mount feet for the IKEA SKÅDIS pegboard, designed to be glued directly to the wall.

The main feature of this design is that it uses M4 hex nuts embedded inside the print. To achieve this, you need to add a pause at a specific layer during printing, insert the nut, and then resume the print.
The pause is already properly configured in the provided 3MF project for Bambu Studio, exactly on the last layer before the model closes, so no manual setup is needed if you use that file.

Hardware:

• M4 screws, length 12–16 mm (both work fine)

• M4 hex nuts (Approx. 2.7 mm thick, Approx. 7 mm across flats)

The screws and nuts used in this project are standard ones from an Amazon hardware kit, nothing special.

Once printed and assembled, the feet can be glued to the wall to securely hold the SKÅDIS board.