Thrustmaster T3PM Pedal Mount for Playseat Challenge

Pedal mounts for the Thrustmaster T3PM pedals that come with the T248 wheel for the Playseat Challenge, it uses four M6 35mm Cylindric head Allen bolts to close the clamp and a M6 20mm Cylindric head Allen bolt to secure it to the pedals, to tighten the 35mm bolts it uses 4 M6 hex nuts of 10mm across flats and 3,5mm thickness, I also added some silicone washers between the pedals and the printed mount but this is optional.
Note: you have to cut the foam covering the Playseat pedal base

Print settings:
2mm Layer Height
15% Infill density (You can change this if you really stomp on those brakes)
Support: Yes, for the nut and bolt incisions (I found out that the tree type support is easier to remove)
Hardware:
16x M6 35mm Cylindric head Allen bolts
4x M6 20mm Cylindric head Allen bolts
16x M6 hex nuts (10mm across flats)