James Webb Hanging Mirror Art Collector Mod

A remix modification to ejunkins James Webb Hanging Mirror Art https://www.thingiverse.com/thing:5232883 using a my remixed version of heavymineral JWST - james webb space telescope Scale 1:100 https://www.thingiverse.com/thing:5234566 I'm unsure of actual scale but visually actuate to the real center Collector on the James Webb Space Telescope. This uses ejunkins original files but replaces the JWST-SectionA.stl file. #4x40 heat-set inserts to mount the panels and #8x32 heat-set inserts to mount the collector to the plate. The lower bottom screw on each panel need to be cut short just long enough to thread into the Panel hole as the design of the collector doesn't allow the screw to be installed once the panel is mounted. Cut the screw and install before mounting the Panels. I used #4x40x1/2in. Truss head screws for the Panels but round head screws should work ok. You don't need to install a heat-set insert here either. I printed the Panels in Black and Silver to mimic the real ones. (Layer1-2 Black, 3-10 Silver, 11-22 Black at .2mm layer height) #8x32 Flat head screws mount the collector to the Section A plate. The wall mounting hole for the plate can be accessed thru the hollow center of the collector. The plugs are press fit into the 4 outer mounting holes once screwed to the wall. The lens cap press fits into the hole of the collector.
Parts Needed:
12 - #4x40 Heat-set Inserts
14 - #4x40x1/2in. Truss head screws
3 - #8x32 Heat-set Inserts
3 - #8x32x1/2in. Flat head screws
NOTE*
12 - M2 Heat-set inserts are needed for the Section A plate as per the original build.