eByte controller vertical support for DIN rail (35mm)

Needed to mount 3 eByte IoT converter modules on a 35 mm DIN rail but space available wasn't enough so I had to rearrange them in vertical position.

The support was designed using the built-in DIN rail support on the eByte to clip and hold the device, and I used the DIN rail clip from https://www.thingiverse.com/thing:4856091 which was fused to the model.

Printing requires no supports and just some added settings for resistance (walls, infill) and flexibility (PETG).

This applies to the following (and other) models:
MA01/02-AACX2220 (2DI+2AI+2DO to RS-485/RS-232 converter)
MA01/02-AXCX4020 (4DI+2DO to RS-485/RS-232 converter)
MA01/02-XACX0420 (4AI+2DO to RS-485/RS-232 converter)

Others:
LS-485to4Ai-V10 (RS-485 to 4 analog outputs
and more that use the same outer case format.

I don't have need (yet) to mount the bigger controllers but may adapt this thing to these in the near future as well. Please write me a line in comments if you need so (I'd just need the exact dimension).

If you find this thing useful, please leave your comments and like ;)