Raspberry Pi Pico DIN rail mount & basket cover

Allows a Raspberry Pi Pico to screw into mount. For use with 35mm DIN rail

Update Notes:
1/23/2026
-Added mount v2_hook option. Made chamfer at bottom of bridge for cover to clip onto. Also carved out notch on bridge to give more stability to cover
-Added mount_cover, a basket like cover that can clip onto the pico mount. This cover does not need supports, likely need to change print orientation to print with the large flat side on the bottom.

Remix of Raspberry Pi Pico DIN rail mount by: Thebrojectlist
Adjusted bottom of the ends to print without support, uses more material (should still use supports for bridges). Made room to allowed for board to be installed upside down so headers can point up. Added wire organizer hook and deepened connector point to allow for bigger usb cords/adapters. Rounded a lot of the edges.