AtGames ALU Steering Wheel Adapter

I created this adapter for a kids playground steering wheel that is available on Amazon and AliExpress. (links included below) . This fits the AtGames Legends Ultimate spinner and is meant for playing steering wheel based games. The steering wheel is relatively cheap and I saw it as a good alternative to printing a whole wheel out.

Once printed, fit the wheel carefully onto the top of the shaft. There are two sets of slotted openings to pop it onto, be aware one of the bits of plastic underneath the playground wheel is slightly larger than the other three. Push down, use a 1/4-20x2 bolt and nut from the inside of the shaft upwards (picture included of the stove bolt set I bought from Home Depot). Place the washer over the center of the steering wheel opening, tighten the nut, and finish with the cap. The shaft itself should pop on and off the ALU spinner pretty easily as long as you apply vertical force, or wiggle very slightly as that might help.
I've used this with Off Road, Super Sprint, and a few other games and it adds a bit more of an arcade feel.

For printing, you will need to enable supports. I would suggest at least 40% infill but it seems to work fine at about 30%. A few different types of PLA have been tested and all seemed to work great. I used 0.1 resolution for the shaft but I don't see why this wouldn't work on 0.2 also. The cap and washer should be fine at 0.2.

A couple of links to the steering wheel used:
https://a.co/d/e0wqz6I
or
https://www.aliexpress.com/item/1005006931546447.html?spm=a2g0o.tesla.0.0.2181VwCYVwCY5h&pdp_npi=6%40dis%21CAD%21C%2417.53%21C%249.99%21%21%21%21%21%402101eee917686173627337835e1b6e%2112000038767837567%21btfpre%21%21%21%211%210%21&afTraceInfo=1005006931546447__pc__c_ppc_item_bridge_pc_same_wf__wqLMmqK__1768617362968