Filament Splice Kit 1.75

Could not find a simple holder for filament to hold to for a splicing jig. Used with 1.75 Filament

So just made a simple 25mm piece to hold the filament while I hold it and melt it together

Update: Realized the original was for short pull through, I added a cut away so you can snap in and out the filament for longer runs
Update: Found the extruder is very picky with filament diameter so I found some pliers and added a clamp clearance for the filament. After splicing, heat filament to soft and clamp with pliers
Update: Plier code is very tight. You will want it tight but be prepared to sane a bit on the connection spool and end of the screw to make sure it smooth