Creality LD-006 Z-stop offset for magnetic build plates

Recently I have acquired an old LD-006 for fairly cheap that came with a magnetic build plate.
I understand now why the previous owner couldn't get it working anymore after fitting this build plate; He had not accounted for the z-stop sensor needing to be tripped about 2,7mm sooner than originally and had promptly sent the machine to crunch the new magnetic build plate into the LCD screen. Whoops.

I measured my specific magnetic build plate (No idea on make, sorry) and made a small filament printed offset block to glue onto my z-stop.... strip.
As you mount a build surface to your build plate that thickens the part that goes towards your FEP and screen, you need to account for that thickness on the z-stop and make sure it extends lower by the same amount so it triggers the Z-stop sensor. Failing to do so can cost you milimeters in prints and worse yet, damage your screen.
And especially with the LD-006 aliexpress or a donor seems your only option in Europe...

--

I have included 3 lengths, 2.7, 3.0 and 3.3mm offset so that you hopefully benefit from this as well accounting for different brands.
Simply put a small dab of superglue on the recessed part and then press your printed offset to the bottom of the z-stop as indicated in the photo - Printed side facing right. You can always do a dry fit to see if it's comfortable.
Print with a .3 or .1 nozzle if possible so the maths work out for your lines. Remember to re-level your build plate and keep a close eye on that z-sensor tucked on the bottom right of your Z-axis rod.

EDIT: Version 2.1 nestles nicely onto the strip. Picture issued is still the version 1 which was trimmed to fit manually.