Sunlu Spool Drawer Shelf for Honeycomb Storage Wall

This is for the Sunlu Spool Drawer system I made to attach it to a Honeycomb Storage Wall. The middle is loose to allow the spool to rotate to access what drawer you need. It also is easy on and off the shelving system to allow you to take the spool off when you need to and to reattach it when done.

As a headsup, it is flimsier than I'd like. I'm going to redesign it soon with another hex below it to add some strength, but it works just fine currently with 3 full drawers. I just wouldn't put a ton of weight into it without a bit of reinforcement in someway.

Elegoo Neptune 4 Pro. 0.6mm nozzle. .24 layer height. PLA. 220/55 nozzle/bed. Tree supports. Took around 2 hours to print with those settings. I think adaptive layer height put it around 1.5 hours or so with those same settings. Layer height could be much higher if you wanted it to be, there is next to no fine detail in this model so you ain't gonna lose anything there. Printing on its side is going to give it the most strength since the layer lines will run with the stress.