F-14 64mm ESC Cover Bottom Plate

I got the concept from another creator on here that made it for the larger freewing F-14. However It was 2 ducts only and you had to cut out parts from some plastics bought at a store. I turned it into this full sheet direct fit and i cleaned up the ducts by making them deeper and wider for better air circulation.

You will need to cut small holes in the planes foam just below where the current vents sit. If you are not sure leave a comment and ill add pics of what i am talking about or look at the original creators process.

There is 2 versions of this depending on the size of your Printer.
The full cover fits on the K2 plus due to the plate size
There is a split version for smaller plate printers
Printed with defaults Creality slicer using PLA