Blink Mini 2k GoPro mount for doorframe

I found the original here: https://www.thingiverse.com/thing:5762672
As it did not fit for my Blink Mini 2k, I modified it using Meshmixer to adjust.
The base (that attaches to a doorframe in my case) has also been modified as I needed a different angle.

Printed just fine for me, using tree support and 15% infill.
The camera part is a snug but not too tight fit, if you find it too loose after printing you might slightly want to downscale it. Be mindful of the fact that downscaling will also change the size of the adapter part.
I used an original rod and hex nut cap from an action cam mount and recommend adding holes to the base to allow for installation using screws - this can easily be done with your slicing software, adjusted to the size of screws you're using.

Note: I did not bother to remove the original microphone cutout. That being said, it is of no use for the Mini 2k, as the camera has its microphone on the front. The hole is on the bottom or top (depending on installation orientation) so probably not visible in most cases.