PCB mount for EG Starts Arcade controller board

This is a little board mount for the USB Controller board that comes with a little DIY arcade controller kit I got from "EG STARTS" on amazon. I had trouble opening one made by Cguz, so I made my own from measurements of my boards.

• The board itself if 85.5mm by 35.75mm with mounting holes drilled into the board that are spaced 30mm by 80mm on center.
• The walls of the housing are low enough that you can still get your fingers around the plugs to remove them.
• The design is scaled up by 10x for best retention of the geometry.
• One version has 3 locations around the perimeter that can be used for screwing it down, or you could use the other one and glue it, or just use screws long enough to go through the board and housing.
• I've included both .stl files as well as the SketchUp files for anyone to work from.