Summary

A combined case for:
-Raspberry Pi 5 Model B
-HQ Camera C/CS Mount
-Camera Module 3

The cameras point in the same direction and the camera cables run outside the case. The case is designed to sit on the holding screw of the HQ Camera.

Print Settings

Printer Brand:

Bambu Lab

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Bambu P1S</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Thick walls, about 1mm, and about 20% infill.</p></div>

Post-Printing

Additional Materials and Assembly

            <div><p>To assemble, the following screws, each with an according metric hex-nut, are needed:<br>-Case:<br>-4x M3x40mm<br>-4x M3x25mm<br>-4x M3x16mm<br>-Pi mount:<br>-4x M2.5x20mm<br>-HQ Camera mount:<br>-4x M2.5x12mm (10mm works as well, but is a bit annoying to assemble)<br>-Camera Module 3 mount:<br>-4x M2x12mm (10mm works as well, but is a bit annoying to assemble)</p><p>Connect the cables before you assemble the parts.<br>You have to feed the cables trough the parts, where they need to be fed trough before you plug them in.<br>200mm or longer cables work. (shorter ones were not tested)</p><p>Assembly order:<br>-mount HQ Camera to the Cams Case and Pi Case<br>-mount Camera Module 3 to Cams Case and Pi Case<br>-mount HQ Camera lid and Camera Module 3 lid to Cams Case and Pi Case<br>-mount Pi to Pi Case and Cams Case<br>-mount Pi Case lid to Pi Case and Cams Case</p></div>

Further Information about the Model

-Some screw and nut tolerances are not perfect, you may have to use force to put screws in and hold nuts during assembly because they are not press-fit.
-I only tested the case with a passive raspberry pi cooler, the active standard cooler should fit, but was not tested.
-The raspberry pi 5 is known to produce a lot of heat. This case may not be beneficial for heat distribution. Be aware of a fire hazard.
-Not all roundings are the same, if you are annoyed by that, look for another case.
-With a modern 3D printer, all parts can be printed without support.
-This model won't be maintained, because i need only one of them. Maybe someone in the community is willing to help you out if you want any changes.

EDIT:
-There's now a model for the Pi 5 and the HQ Camera only.

Raspberry Pi 5 Model B, HQ Camera C/CS Mount and Camera Module 3 Case