Summary

First project built from scratch. Its a fully functional CONNECT 4 complete with a dump bar at the bottom to let all the pieces fall out.

It is a snap together design i printed with PLA (so i dont know how it will work with ABS Shrinkage)

Instructions

You need

2x connect4 Board x2.stl

8x connect4 Joiner x8.stl

1x connect4 Dump Bar x2.stl

21x connect4 Piece x21 x2.stl
and in a different color another
21x connect4 Piece x21 x2.stl

2x connect4 Holder x2.stl

Attach the joiners to one side of the board (they fit only one way)

Put the "DUMP BAR" into the groove (doesnt matter which way it goes)

Place the other side on top and position the jointers in place (dump bar should also fit in place)

Press HARD to snap it all together

Put down the two base parts so the it is flat and simply slide the board into the groove.