Pinball machine shooter rod handle

This is the plastic part of a generic pinball machine shooter rod. It fits both, the Williams and current Stern shooter rods. It's intended as either permanent or temporary use if the plastic handle part shatters and there's no replacement at hand.

It should be compatible with at least the following part numbers:

• Williams 20-9253-7
• Stern 515-6557-01

Get rid of the old plastic part pieces if some are attached. You can just heat them up and scrape as they soften. This part is intended to need a slight force when inserted over the knurling. Epoxy is suggested to be used as an adhesive, put some on the insides, wipe the excess as the metal part is inserted. Let it cure fully before assembling.

Suggested materials are ABS or ASA, around 1.2mm walls and high infill.