Soft light lamp

A simple lamp for home decor. Gives off soft calming orange light.

For this build you would need:

• Printed models.
• TWO E27 light bulb sockets with screw-on nuts. You need TWO socket nuts for the build.
• E27 lightbulb.
• Electical wire with a switch and a plug.
• Two WAGO cable clamps for wiring.

How to build:

1. Print all the models.

   • Print the lid and the base facing downwards to the build plate. This will remove the need for supports.
   • Print the base cover to hide all the wiring.
   • Print lamp body on the highest quality your printer allows. This takes a lot of time: my Elegoo Neptune 4Pro took ~18 hours to print. Make sure buildplate adhesion is good and keep an eye on the print while the body's flat base is being printed.
     You can burn off any excess strings of filament inside the lamp body if they bother you.
2. Use a E27 lightbulb socket and two socket nuts to screw lamp base and lamp body together.
3. Connect lightbulb socket wires with electrical wire via wago cable clamps (or use any other fire-safe wire connection method, since we're dealing with mains voltage)
4. Screw the lightbulb into socket.
5. Put the lid on. (You can skip this step if you need more light)

Engineered and built for Elemendaria