Orangatang Kegal 36t pulley 5mmHTD Pitch uses a 9mm wide belt for Electric Skateboard

Electric skateboard wheel Pulley for Orangatang Kegal wheels.

PRINT AND USE THESE FILES AT YOUR OWN RISK.

General Print settings to get you started settings assume ABS plastoc

1. ONLY Print using High-temp high impact plastic, ABS or stronger. PLA does not work, it will melt.
2. Layer Height .20mm 5 outer layers
3. Infill 60% Hexigon
4. Print Speed 60mm/s
5. Temp 225c extruder 115c bed
6. No supports
7. Always print on a glass bed using acetone slurry that is 95% acetone 5% abs filament by volume.

I put some kits up on ebay if anyone wants them printed with all the bolts and belts.
Also If you need any special pieces made or would like to buy any of my parts pre-printed or electric skateboard electronics please email me at [email protected]