Sunshade for Nexus 7

This is a sunshade for my tablet holder that fits a DJI Phantom 2 controller clamp:
http://www.thingiverse.com/thing:702647
It will not work with the older obsolete version.
This one is printed as four flat parts and then snapped together.
You can use CA glue or acetone slurry or plain acetone to glue it if you want.

I have also included my original design which I could not get to print without warping or delaminating. It has extra pads which can be cut off and you should use a brim. If you can get it to print properly, great. I couldn't and settled for the four piece design which is lighter.

I did not orient all the parts for printing as I normally do. If you do not know how and need the bottom and sides rotated for printing, leave a comment here. The assembly is not intended for printing so don't waste your time downloading it. The left and right sides are actually the same part (flipped).