Summary

Made with PrintShop ShapeMaker, This was actually the first scan I did. Took about 15 minutes. I wish I could afford a z18 because I would have a suit already!!!

Instructions

I would suggest slowing it down for fine detail but it was created under .35mm tip guidelines!

{
"blur" : 5,
"scalar" : 1.041667,
"extrudeHeight" : 35,
"translationX" : 512,
"translationY" : 384,
"y0" : 102.5,
"x0" : 15.32609,
"offsetHeight" : 0,
"backingType" : 62,
"y1" : 391.9865,
"threshold" : 0.2353941,
"x1" : 486.8333
}

04-19_0819 NightWing Bracer Spikes