Summary

I made this to hold my rings.

Instructions

1) I made this project in inventor
2) I created a new sketch, and made circle. The, I extruded it to about 0.25 inches
3) Then, I made another smaller circle on top of the previous one and extruded it to 3 inches
4) After, I made circles on the pole, extruded them inwards, and deleted them to make the holes on the pole the same size as the poles i was sticking in them.
5) I used the revolution tool to make a sphere on top.
6) Isaved my project as an STL.
7) I was ready to print on the makerbot, so I had to generate a G code
8) Finally, I printed to pole
9) When it was done i just cut wooden poles to 1.5 inches and stuck them in the holes.

Ring Holder