DaVinci 1.0 E3D v6 Fan Shroud

After installing an E3D v6 using http://www.thingiverse.com/thing:707530 I wanted to make a fan shroud for the old stock 40 mm extruder fan, so I made one based loosely off of http://www.thingiverse.com/thing:641370. Really easy swap since you can use the same fan and connections, and the DaVinci repetier firmware allows you to control the fan settings for each print!

Update:
I added version 2 that's raised 2.5mm on the bottom so that it doesn't hit the contact screws on the bed, though I haven't tested the new version.