Summary

Clips for mounting a BeagleBone Black to standard 35mm DIN rail.

Instructions

Download and print one of each clip ( bbb_Din_clip_1.stl & bbb_Din_clip_2.stl ) for each BBB. Two different clips are required because the hole spacing is not the same on either end of the board. Use M3 screws to fasten the BBB to the clips and then hang the clips on the rail and snap it in. ( the flexible tabs should be on the bottom ). If you have a M3 tap, chase the holes first to make threading the screws easier.
A single Scad was used to generate both clips by merely changing the required hole spacing. ( the required hole spacing for both clips is in the comments ).
The .dxf file has been modified from the original file that this was remixed from because the overall length was too short. In the process, the DIN rail profile was also eased up a bit to make it easier to snap the clips onto the DIN rail.
Nothing notable regarding slicing or heat settings for print.

BeagleBone black DIN rail clips