Remix of Arduino case for Adafruit PowerBoost 500 shield and Ultimate GPS

Remix of Arduino case to hold my GPS logger project which is:

Arduino Uno, Adafruit PowerBoost 500 shield (And li-po battery) and finally the ultimate GPS shield itself.

I moved the case out 5mm to fit the 2 shields a bit better. I also tweaked the USB/Power holes to better allow the 2 shields to slide into palce.

I used 35mm M3 screws with some spacers to hold it in place. Ideally 30mm-32mm M3 screws would be used.

Lid has been added, it friction fits decently, but could be tweaked.

I printed this on a PrintrBot Simple Metal with .3mm resolution and 34% infill per original project specs.