Kanto YU2 - 7.5 Degree Angle stand including port extension.

This past Christmas I was given some wonderful Kanto YU2 powered speakers. Although the sound quality and volume exceeded my expectations I was unable to take advantage of the suggested positioning of the speakers so I created this stand which allowed me to direct that port forward without it being placed close to your back wall (http://i.imgur.com/aEXPduS.png).

I built this design to use no supports and build in two separate pieces. After printing both parts use #6 self tapping plastic screws to attach both pieces.

Isolation pads from your YU2 should be removed and attached to the bottom of the newly printed stands.

You will need:
2 Printed (base.lower.stl)
2 Printed (base.upper.stl)
4 Purchased #6 Self Tapping Screws