Folding Small Parts Tray - Revised

Revised: 12-14-15

1. Reduced the radius at the outside bottom of the tray. Cleaned up the print in that area.
2. Added finger clearance holes to make opening easier.
3. Added clearance in the hinge area so the box closes better.

Also found a jumbo paper clip makes a great hinge rod. Push it through, make a short bend in the end, pull tight to part, bend other end and clip off excess as close to the hinge as possible.

120 mm Square parts tray that folds in half to keep parts in.

Used a piece of 14 AWG copper wire as a hinge. Takes a bit of work to thread the wire.