GoPro Hero 3 - Vibration elimination mount

You can squeeze your GoPro Hero 3 into the slim case. It is a WIP, because I didn't make any holes for the wireless button (wich you need, so please(!!!) drill a hole there, otherwise your wireless will turn on and off all the time over and over again. And you also should drill a hole for the USB/video-out in case you need the camera for FPV also.

Have fun!

• Print one slim case
• two side holders
• one back plate (made for a rcexplorer.sw TriCopter)

You need four 3mm or similar screws, four small rubber bands and six hear protection plugs. Perfect results when you are able to balance your props and motors. It may even work without perfectly balanced props and motors - please write your experience in the comments down below!