Summary

Need a tray to hold all the support scraps while you clean your part? Look no further! All you need besides this Thingy is a roll of 2" wide tape of your choice.

Instructions

Print Settings:

0% infill (walls are only 0.8mm, printed on a 0.4mm nozzle)
0.3mm layer height
1 extra shell
65 mm/s feedrate
65 mm/s travel feedrate
225c extruder temp
115c HBP temp

At these settings, the Sticky Tray should only take about 10 minutes to print. Afterwards, just peel about 3.5" worth of 2" wide tape, and stick the tray on top.

All the junk bits from your clean up job should stick to the tape surface on the bottom... instead of flying every which direction when you accidentally press on the side of the tray. Yay!